Step 1 Main Board
-
Flip the projector right-side up and turn it so that the back ports are facing you.
-
Remove the 7mm metallic hex screws using the flat-head screwdriver.
-
Remove the two black 10mm screws using the T10 Torx screwdriver head. The screws are located at the center of the back panel.
Step 2
-
Flip the projector over.
-
Remove the two 77mm screws that are located nearest to the back panel ports. Use the T10 Torx screwdriver head.
-
Next, remove the two 10mm screws located near the lens side with the T10 Torx screwdriver head.
-
Flip the projector back over.
-
Unplug the speaker wire from the circuit board by simultaneously squeezing the sides and pulling.
-
Pull on the brown tabs located at the sides of the white plastic ribbon holder and pull the ribbon out.
-
Pull the top cover back.
-
Remove the cables from the white tabs.
-
Remove the five 5mm screws located throughout the motherboard with the screwdriver. Use the T10 Torx screwdriver head.
-
Pull up on each metal tab located at the rear of the projector. There are 5 tabs.
Step 6
-
Remove the three gold ribbons by flipping up the black taps that hold the ribbon in place.
-
Pull the ribbons out carefully and place them under the main board.
-
Carefully lift the entire main board up.
Step 7 Lens
-
Remove the two 10 mm screws using the Philips 0 screwdriver head.
